Elsevier

Clinical Biomechanics

Volume 12, Issue 1, January 1997, Pages 22-31
Clinical Biomechanics

Paper
Arm and trunk posture during work in relation to shoulder and neck pain and trapezius activity

https://doi.org/10.1016/S0268-0033(97)00048-XGet rights and content

Abstract

Objective. To investigate work technique in relation to work-related shoulder and neck pain (SNP) and upper trapezius muscle activity.

Design. A matched pair, case-control field study of female employees with and without SNP.

Background. It has proved difficult to distinguish subjects with SNP from those without by vocational electromyographic recordings from the upper trapezius muscle. Other potential risk indicators include psychosocial factors and work technique. This study focuses on the latter.

Methods. Manual (14 pairs) and office workers (24 pairs) were recorded during a 30-min work period. Simultaneous recordings of upper trapezius activity by surface electromyography and arm and upper back postures by inclinometers were analysed.

Results. Cases and controls were not differentiated on the basis of arm elevation or of trunk posture in the sagittal plane. No significant correlations were found between variables averaging the muscle activity and the arm elevation over the recording period. Statistically significant correlations were, however, found between these variables when analysing recordings at high time resolution (0.2 s) and adjusting for the delay in arm elevation relative to the upper trapezius muscle activity (r = 0.43, manual group; r = 0.32, office group).

Conclusions. Factors other than arm elevation probably contribute more significantly to the load in the upper trapezius muscle, and to the development of work-related SNP in work situations with moderate arm elevation.

References (35)

  • E. Grandjean
  • D.B. Chaffin et al.
  • K.B. Veiersted et al.

    Electromyographic evaluation of muscular work pattern as a predictor of trapezius myalgia

    Scand J Work Environ Health

    (1993)
  • C. Jensen et al.

    Trapezius muscle load as a risk indicator for occupational shoulder-neck complaints

    Int Arch Occup Environ Health

    (1993)
  • A. Aarås et al.

    Postural angles as an indicator of postural load and muscular injury in occupational work situations

    Ergonomics

    (1988)
  • G. Sigholm et al.

    Electromyographic analysis of shoulder muscle load

    J Orthop Res

    (1984)
  • K. Schüldt et al.

    Effects of changes in sitting work posture on static neck and shoulder muscle activity

    Ergonomics

    (1986)
  • Cited by (24)

    • The ability of limited exposure sampling to detect effects of interventions that reduce the occurrence of pronounced trunk inclination

      2010, Applied Ergonomics
      Citation Excerpt :

      In research, ten or fewer work cycles have been used to characterize posture profiles in many studies of “repetitive” work, both for epidemiologic purposes (e.g., Harber et al., 1992; Marras et al., 1993; Ohlsson et al., 1995; Fallentin et al., 2001) and in ergonomics intervention evaluation (e.g., Häkkänen et al., 1997; Björing and Hägg, 2000). In less routinized jobs, posture recording periods of less than one hour are common, both in observation-based studies (Burdorf, 1992; Burdorf et al., 1997; Rolander et al., 2005; van der Beek et al., 2005), and when technical measurement equipment has been used (e.g., Bao et al., 1996; Vasseljen and Westgaard, 1997; Juul-Kristensen et al., 2001; Balogh et al., 2006). The intervention scenarios selected for this study were intended to represent a set of feasible interventions of varying effectiveness, ranging from fairly modest – a 10% reduction in exposure for the upper 1/8 of the exposure distribution, causing the occurrence of pronounced trunk inclination in the job to decrease by about 0.5 %time, cf. Table 1 – to substantial: a 50% reduction in exposure for the upper 1/2 of the exposure distribution, leading to 6.5–10.9 percent of the job changing from being performed with a trunk inclination larger than 20° to being performed at less than 20°.

    • Validation of tri-axial accelerometer for the calculation of elevation angles

      2009, International Journal of Industrial Ergonomics
      Citation Excerpt :

      An inclinometer is a transducer that measures the elevation/inclination angle relative to gravity. Different types of transducers have been developed and are used to measure elevation angle exposure such as the abduflex (Fernstrom and Ericson, 1996; Svendsen et al., 2005) consisting of mercury microswitches, Intometer (Sporrong et al., 1999) consisting of pressure transducers and distilled water, Physiometer (Vasseljen and Westgaard, 1997) consisting of electrolytic liquid level sensors, and linear accelerometers (Bernmark and Wiktorin, 2002; Estill et al., 2000; Hansson et al., 2006, 2001a; Moller et al., 2004; Mathiassen et al., 2003). Linear accelerometers are commercially available and are commonly used in evaluation of segments' posture by means of uni-axial (Paquet et al., 2001), bi-axial (Boonstra et al., 2006) and tri-axial (Hansson et al., 2001b) accelerometers.

    • Neck postures in air traffic controllers with and without neck/shoulder disorders

      2008, Applied Ergonomics
      Citation Excerpt :

      Work-related musculoskeletal disorders (WRMSD) in neck and shoulders are frequently reported among computer operators (Gerr et al., 2002; Brandt et al., 2004). Several studies of clinical effects of disorders, or their mechanisms, have focused on the issue whether subjects with WRMSD show other patterns in motor performance, in terms of postures, movements and muscular load, than healthy subjects (Hägg and Åström, 1997; Vasseljen and Westgaard, 1997; Madeleine et al., 1999, 2003; Szeto et al., 2002). These studies have shown conflicting results: Vasseljen and Westgaard (1995) found consistent associations between pain and increased activity in the trapezius muscles among manual workers, but not in office workers.

    • Ergonomic analysis of postural and muscular loads to diagnostic sonographers

      2007, International Journal of Industrial Ergonomics
    • Structural stability and reliability of the Swedish occupational fatigue inventory among Chinese VDT workers

      2004, Applied Ergonomics
      Citation Excerpt :

      Ahsberg et al. further asserted that the three subscales were accounted for because of the maintenance of a high state of vigilance and prolonged sitting in a static posture. Besides the intensive cortical activation and hormonal stress which results in general tiredness and declined motivation (Kandel et al., 2000), the long period of static posture and keyboard operation triggered musculoskeletal discomfort such as numbness, muscle soreness, and joint stiffness (Siu et al., 1999; Vasseljen and Westgaard, 1997; Westgaard and Aaras, 1984). Likewise, workers who use a VDT for 4 h or more per day are potentially more vulnerable to occupational fatigue.

    View all citing articles on Scopus
    View full text