Skip to main content
Log in

Characterisation of the Glass Transition of an Amorphous Drug Using Modulated DSC

  • Published:
Pharmaceutical Research Aims and scope Submit manuscript

Abstract

Purpose. The use of modulated differential scanning calorimetry (MDSC) as a novel means of characterising the glass transition of amorphous drugs has been investigated, using the protease inhibitor saquinavir as a model compound. In particular, the effects of measuring variables (temperature cycling, scanning period, heating mode) have been examined.

Methods. Saquinavir samples of known moisture content were examined using a TA Instruments 2920 MDSC at a heating rate of 2°C/min and an amplitude of ± 0.159°C with a period of 30 seconds. These conditions were used to examine the effects of cycling between - 50°C and 150°C. A range of periods between 20 and 50 seconds were then studied. Isothermal measurements were carried out between 85°C and 120°C using an amplitude of ± 0.159°C with a period of 30 seconds.

Results. MDSC showed the glass transition of saquinavir (0.98 ± 0.05%w/w moisture content) in isolation from the relaxation endotherm to give an apparent glass transition temperature of 107.0° C ± 0.4C. Subsequent temperature cycling gave reproducible glass transition temperatures of approximately 105°C for both cooling and heating cycles. The enthalpic relaxation peak observed in the initial heating cycle had an additional contribution from a Tg 'shift' effect brought about by the difference in response to the glass transition of the total and reversing heat flow signals. Isothermal studies yield a glass transition at 105.9°C ± 0.1°C.

Conclusions. MDSC has been shown to be capable of separating the glass transition of saquinavir from the relaxation endotherm, thereby facilitating measurement of this parameter without the need for temperature cycling. However, the Tg 'shift' effect and the number of modulations through the transition should be taken into account to avoid drawing erroneous conclusions from the experimental data. MDSC has been shown to be an effective method of characterising the glass transition of an amorphous drug, allowing the separate characterisation of the Tg and endothermic relaxation in the first heating cycle.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

REFERENCES

  1. M. Reading, D. Elliott, and V. Hill. MDSC, a new approach to the calorimetric investigation of physical and chemical transitions. J. Therm. Anal. 40:949–955 (1993).

    Google Scholar 

  2. M. Reading. Modulated differential scanning calorimetry—a new way forward in materials characterisation. Trends Poly. Sci. 1:248–253 (1993).

    Google Scholar 

  3. N. J. Coleman and D. Q. M. Craig. Modulated temperature differential scanning calorimetry: a novel approach to pharmaceutical thermal analysis. Int. J. Pharm. 135:13–29 (1996).

    Google Scholar 

  4. A. Boller, Y. Jin, and B. Wunderlich. Heat Capacity measurement by modulated DSC at constant temperature. J. Therm. Anal. 42:307–329 (1994).

    Google Scholar 

  5. J. Kerc and S. Srcic. Thermal analysis of glassy pharmaceuticals. Thermochimica Acta 248:81–95 (1995).

    Google Scholar 

  6. C. F. Fox. Putting proteins under glass. Science 267:1922–1923 (1995).

    Google Scholar 

  7. B. C. Hancock, G. Zografi. Characterisation and significance of the amorphous state in pharmaceutical systems. J. Pharm. Sci. 86:1–12 (1997).

    Google Scholar 

  8. M. Yoshioka, B. C. Hancock, G. Zografi. Crystallisation of indomethacin from the amorphous state below and above its glass transition temperature. J. Pharm. Sci. 83:1700–1705 (1994).

    Google Scholar 

  9. B. C. Hancock, S. L. Shamblin, G. Zografi. Molecular mobility of amorphous pharmaceutical solids below their glass transition temperatures. Pharm. Res. 12:799–806 (1995).

    Google Scholar 

  10. M. J. Richardson, N. G. Savill. Derivation of accurate glass transition temperatures by differential calorimetry. Polymer 16:753–757.

  11. V. L. Hill, D. Q. M. Craig, L. C. Feely. Characterisation of spraydried lactose using modulated differential scanning calorimetry. Int. J. Pharm. 161:95–107 (1998).

    Google Scholar 

  12. D. G. Archer. Thermodynamic properties of synthetic sapphire (alpha-Al2O3), standard reference material 720 and the effect of temperature-scale differences on thermodynamic properties. J. Phys. Chem. Ref. Data, 22:1441–1453 (1993).

    Google Scholar 

  13. C. T. Moynihan, S. K. Lee, M. Tatsumisago, T. Minami. Estimation of activation energies for structural relaxation and viscous flow from DTA and DSC experiments. Thermochimica Acta 280/281:153–162 (1996).

    Google Scholar 

  14. 14.TA Instruments Ltd Modulated DSC Compendium (1997).

  15. A. A. Lacey, C. Nikolopoulos, and M. Reading. A mathematical model for modulated differential scanning calorimetry J. Therm. Anal. 50:279–333 (1997).

    Google Scholar 

  16. A. Boller, I. Okazaki, and B. Wunderlich. Modulated differential scanning calorimetry in the glass transition region. Part III evaluation of polystyrene and poly(ethylene terephthalate). Thermochimica Acta 284:1–19 (1996).

    Google Scholar 

Download references

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Royall, P.G., Craig, D.Q.M. & Doherty, C. Characterisation of the Glass Transition of an Amorphous Drug Using Modulated DSC. Pharm Res 15, 1117–1121 (1998). https://doi.org/10.1023/A:1011902816175

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1023/A:1011902816175

Navigation