Quantitative analysis of the frictional properties of solid materials at low loads. I. Carbon compounds

Udo D. Schwarz, Oliver Zwörner, Peter Köster, and Roland Wiesendanger
Phys. Rev. B 56, 6987 – Published 15 September 1997
PDFExport Citation

Abstract

Load-dependent studies of the frictional properties of the carbon compounds graphite, diamond, amorphous carbon, and C60 were performed by friction force spectroscopy in air and dry argon. During the experiments, the surface was profiled at low loads without wear or plastic deformation. The tips used for profiling were fabricated according to a special production procedure in order to obtain apexes with a well-defined spherical shape and known apex radius. The data obtained were compared with a theoretical model based on the contact mechanical analysis of a Hertzian-type tip/sample contact with small tip radius, low surface energies, but not too low elastic moduli of the tip and sample material. Our experimental results are in excellent agreement with a FfFn2/3 dependence of the frictional force Ff on the normal force Fn as predicted for this case. These findings suggest that contact mechanical models, in spite of being based on continuum elasticity theory, are valid for tip radii down to a few nanometers and that the shear stress is constant within the elastic regime. Additionally, it was shown that the friction coefficient μ=Ff/Fn is not well suited for comparing the tribological behavior of different materials in the case of single-asperity friction. Therefore, an effective friction coefficient for point-contact-like single-asperity friction was introduced for the classification of the microscopic frictional properties of materials. As quantitative results, high microscopic friction was found for C60 thin films, medium friction for amorphous carbon and diamond, and very low friction for graphite.

  • Received 20 February 1997

DOI:https://doi.org/10.1103/PhysRevB.56.6987

©1997 American Physical Society

Authors & Affiliations

Udo D. Schwarz, Oliver Zwörner, Peter Köster, and Roland Wiesendanger

  • Institute of Applied Physics and Microstructure Research Center, University of Hamburg, Jungiusstrasse 11, D-20355 Hamburg, Germany

See Also

Quantitative analysis of the frictional properties of solid materials at low loads. II. Mica and germanium sulfide

Udo D. Schwarz, Oliver Zwörner, Peter Köster, and Roland Wiesendanger
Phys. Rev. B 56, 6997 (1997)

References (Subscription Required)

Click to Expand
Issue

Vol. 56, Iss. 11 — 15 September 1997

Reuse & Permissions
Access Options

Authorization Required


×
×

Images

×

Sign up to receive regular email alerts from Physical Review B

Log In

Cancel
×

Search


Article Lookup

Paste a citation or DOI

Enter a citation
×